|
|
|
DTA Régulatuer température standard |
 Caractéristiques
Régulateur de température DTA
Temperature controller is a measurement device used on temperature control. Thermocouple-type and resistor-type temperature controllers measure temperature electronically, obtaining the temperature change from the sensor and sending the measured data to the electronic processor. The output device will then control the temperature variation within a specific range.
Delta's DT series temperature controller has fast output response, accurate PID parameter auto-tuning, support Modbus communication protocol and is built-in with various output types, allowing different systems to reach a stable control status very quickly. Besides, all series are complied with international installation dimension and CE, UL international safety approvals. |
Gamme
¡EPID / On-Off/ manual input control modes
¡EAuto-tuning PID parameters
¡EVarious thermocouple (B, E, J, K, L, N, R, S, T, U, TXK) and platinum RTD (PT100, JPT100) can be set by parameters
¡EBuilt-in 2 groups of alarm switches with 13 alarm modes each
¡ECelsius or Fahrenheit temperature display
¡E2 key lock functions: (1. lock all keys; 2. lock only function key, up/down keys are still workable)
¡EPanel size: 4848, 4896, 9648, 7272, 9696
¡EOptional RS-485 communication interface (Modbus ASCII, RTU, baud rate: 2,400 ~ 38,400)
¡EOptional CT (wire breaking detection) function, an alarm output
¡ESampling time of sensor: 0.5 second/time
¡ECertifications: IP5X protection, CE, UL
Dimensions:
DTA 24x48
DTA 48x48
DTA 49x96
DTA 96x96 |
Documents
 Commercial DTA.pdf...
Doc Technique DTA...
|
|
|
|
